Suspension & steering
Coilover installation
The suspension job that ends at an alignment rack, always. Stored spring energy, seized fasteners, and one-time-use hardware set the hazard picture, and preload and height settings belong to your kit's own documentation. Tools and hazards below.
Effort
- Skill
- 3/5
- Physical
- 4/5
- Diagnostic
- Not rated
- Consequence
- 5/5
- Time
- Not estimated
Each axis is rated 1 to 5 against the catalog's shared difficulty scale. An axis without a rating is unknown, not easy. A time estimate appears only when BuildBay can stand behind one.
Tools this job calls for
Requirement levels come straight from the job catalog. Required tools block the job; the rest make it faster, cleaner, or safer.
- Breaker bar (1/2")Required
- Low-profile floor jackRequired
- Jack stands (pair, rated)Required
- Metric socket set (1/4" + 3/8")Required
- Torque wrench (1/2", 30–150 ft-lb)Required
- Triple-square (XZN) bit setRequired
- Wheel chocksRequired
- Cordless impact wrenchRecommended
- Coil spring compressorRecommended
- Work light / headlampRecommended
Vehicle-specific notes
Where verified data exists for this job, and how far each row is verified. The values themselves (capacities, torque) live in the product, attached to an exact vehicle: an unsourced value never gets printed, and this page prints no values at all.
No verified rows exist yet for this job.
See if your garage is ready
BuildBay checks this job's required tools against your inventory and shows what is missing before the car comes apart.